AC Repair
Original condensers, worn capacitors and attic air handlers that quit in the heat. We find the fault and price the fix before we touch it.
Cedar Park AC repairCedar Park Homes, Twenty Summers In
The neighborhoods off Bell Boulevard, 1431 and Brushy Creek were built with equipment that has now run two decades of Texas heat. Radiant repairs it honestly and replaces it only when that is the better deal.
Cedar Park is where northwest Austin turns into the Hill Country. The ground goes to limestone, the trees go to Ashe juniper, and the neighborhoods spread out from Bell Boulevard along US 183, the 183A toll road and FM 1431 toward Brushy Creek and Lake Travis. Most of the housing went up between the mid-1980s and the late 2000s: Buttercup Creek and the streets around the old highway first, then Twin Creeks, Ranch at Brushy Creek and the subdivisions that now run to the Leander line.
Radiant has served Cedar Park since 1999. The calls we get here are the calls a twenty-year-old house makes. An air conditioner that was original to the build and has finally given out, usually on a weekend in July. A gas furnace in the attic that nobody has looked at since it was installed. A water heater in the same attic, above the bedrooms. Water off Lake Travis that is hard enough to scale everything it touches. And, in the older homes, a generation of plumbing and wiring that was not designed for tankless heaters, induction ranges and cars that plug in.
Cedar Park is inside our Austin service area, so our licensed electricians work here alongside our plumbers and HVAC technicians. Whichever one you need, the visit runs the same way: a diagnosis, a plain explanation, a price you approve before work begins, and the Home Comfort Guarantee behind all of it.
Everything a 1990s or 2000s house needs at this age, plus the upgrades newer homes ask for.
Original condensers, worn capacitors and attic air handlers that quit in the heat. We find the fault and price the fix before we touch it.
Cedar Park AC repairA spring tune-up catches the weak capacitor and the clogged condensate line before they become a July emergency.
Book a tune-upCedar Park water scales water heaters, fixtures and glassware. A properly sized softener stops it at the main line.
Softener optionsPressure regulators, gray polybutylene in the older neighborhoods, gas lines and fixture work from licensed plumbers.
Cedar Park plumbersAttic tanks over finished ceilings. We repair what can be repaired and tell you honestly when the tank is at the end.
Water heater helpEV chargers, standby generators, panel replacements and added circuits from licensed electricians, permitted and inspected.
Electrical serviceAttic gas furnaces from the original build, checked for cracked heat exchangers and failing igniters before winter.
Furnace serviceSlow kitchen lines, backed-up tubs and main-line clogs cleared with the right tool, backed by our no-backup promise.
Clear the drainLocal Knowledge
Cedar, literally. The town is named for the Ashe juniper that covers the hills, and every December through February it releases the pollen behind cedar fever. A well-sealed duct system and a real whole-house filter do more for a Cedar Park household in winter than any air purifier on a nightstand.
Limestone ground, hard water. Cedar Park sits on the Edwards Plateau. Trenching for a sewer or water line means cutting rock, so we lean on camera inspections and exact leak location before anyone digs. The water, drawn from Lake Travis, has passed through the same limestone and carries plenty of it. Scale on a water heater element or a tankless heat exchanger is the most common reason either one dies early here.
Attics that do the heavy lifting. Most homes in Twin Creeks, Buttercup Creek and the 1431 corridor put the air handler, the gas furnace and often the water heater in an attic that hits 130 degrees in August. Duct joints loosen, condensate drains grow algae, and a tank failure lands on the ceiling below. A drain pan with a working float switch is not optional up there.
Two-story heat. Many of these houses run a single system for both floors, which is why the upstairs bedrooms sit five degrees warmer all summer. Balancing dampers, sealing the ducts and, in some cases, zoning or a second system fix that; a bigger unit alone does not.
Older pipe in older streets. Some 1980s and early-1990s Cedar Park homes were plumbed with gray polybutylene supply line, which becomes brittle with age. If yours has it, a planned repipe beats an unplanned flood.
Freeze risk. Attic tanks and exposed lines on north walls froze across the city in February 2021. Insulating them is a small job with a large payoff.
Cedar Park, Brushy Creek and the 183A corridor, with Leander to the north and Round Rock to the east.
Save on the work your home needs most.
It depends on what failed. R-22 is no longer produced in the United States, so the refrigerant itself has become expensive, and any repair that involves opening the sealed system, such as a leaking coil or a failed compressor, means paying that price for a system with few years left. A capacitor, contactor or fan motor on an R-22 unit is still a reasonable repair. We give you both numbers: the repair, and a replacement sized for the house with financing laid out. If the repair is small, we will say so. If you are about to spend a third of a new system on an old one, we will say that too.
Hard enough that most homes here benefit from a softener. The city draws from Lake Travis, and that water carries dissolved limestone from the whole watershed above it. Sizing is about people and fixtures more than floors: a family of five with three bathrooms uses more water, so the softener needs more resin capacity or it will regenerate constantly. We look at your household, the hardness at your tap, and where the main line enters, then recommend a size. A softener paired with reverse osmosis at the kitchen sink covers both the appliances and the drinking water. We will also tell you if your tankless heater already needs descaling.
Yes to both. Cedar Park is inside our Austin electrical service area. A Level 2 EV charger needs a dedicated circuit, usually 40 to 60 amps, and a standby generator needs a transfer switch tied into the panel. A 2000s home with a 200-amp panel often has the capacity; the question is open breaker slots and how much load is already on it. Older Bell Boulevard-area homes with 100-amp service sometimes need the panel replaced first. Our licensed electricians calculate the load, tell you what is required and what is optional, pull the permit and handle the inspection. More on our generator and EV charging pages.
Because the air handler is in a hot attic. The condensate line carries the water your system pulls out of the air, and in a 130-degree attic that line grows algae fast. When it plugs, water backs up into the drain pan, the float switch trips and the system shuts down to keep from flooding the ceiling. That is the switch working correctly. The fix is clearing the line and treating it, then keeping it clear: a seasonal tune-up includes flushing the line and checking the pan and switch. If the line was installed with a low spot or no cleanout, we can correct that so it stops being an annual event.
Don't just take our word for it — hear from our satisfied customers